1
Questions? Technical Issues? The Survival Guide / Display not working properly....help!
« on: September 23, 2012, 08:11:44 am »
I have searched the forum for an answer to this but not sure I have found one. I was making Thermomixer's rocket pesto just now (it is lovely) and as I finished the last bit I noticed the LED display was looking odd.
Since then (ten minutes ago) it has gone mental. It shows fractions of numbers and all the 'function's are lit as if I am weighing, kneading, and reversing all at the same time. If I try and weigh something it just jumps all over the place.
I have checked for moisture (as far as I know it hasn't gotten wet) and cleaned it, turned it off and on more than once, checked for obstructions etc. I do not know where to go from here and can't find anything on the web that fits.
Can anyone offer any advice? I am freaking out a little bit. I have had it for about 15 months and so far no problems other than needing the blade replaced at 12 months.
Cheers,
Serena
Since then (ten minutes ago) it has gone mental. It shows fractions of numbers and all the 'function's are lit as if I am weighing, kneading, and reversing all at the same time. If I try and weigh something it just jumps all over the place.
I have checked for moisture (as far as I know it hasn't gotten wet) and cleaned it, turned it off and on more than once, checked for obstructions etc. I do not know where to go from here and can't find anything on the web that fits.
Can anyone offer any advice? I am freaking out a little bit. I have had it for about 15 months and so far no problems other than needing the blade replaced at 12 months.
Cheers,
Serena